How to open Foaming Spray BottleUpdated 15 days ago
TL;DR: Foaming Spray Bottle is built exclusively for Koh foaming products. Twist off Foamer Trigger Head, fill to the line from a compatible refill, prime the pump, and foam. Video walkthrough below.
Can I watch a video walkthrough?

✓ Need a replacement head?
Foamer Trigger Head is available separately. Swap it out and your bottle is good as new.
How do I set it up?
✓ Steps 1 and 2
Twist off Foamer Trigger Head by turning anti-clockwise. If it's stiff, press down firmly on top as you twist.
Decant from your refill box to the fill line. It sits about 1 cm below the shoulder, exactly 300 mL capacity.
✓ Step 3: prime and foam
Prime the pump by pulling the trigger vigorously 2 to 3 times. Then use one full pull for a burst of foam, or successive rapid pulls for continuous foam.
What if the head is stuck?
⚠ Freeze method
Pop Foamer Trigger Head in the freezer for 5 to 10 minutes. The cold contracts the plastic and can help loosen the seal.
⚠ Warm water method
Run the head under warm (not hot) water for 60 to 90 seconds. The slight expansion can free up any stubborn air-seal that's formed.
What if it clogs?
⚠ Clear the blockage
Dried product can build up in the head after a stretch without use. Twist off Foamer Trigger Head, submerge it in warm water and pump the trigger 12 or more times while it's under to flush it through, then reattach it. If foam stops mid-use, hold the bottle upright. Foaming Spray Bottle is designed for upright use, and extreme tilting can interrupt the pump.
What refills can I use with it?

Need a spare?
Foamer Trigger Head is sold separately. Swap it out if yours ever gets worn or damaged. No need to replace the whole bottle.

New at Koh?
Bathroom & Shower Starter Kit pairs Bathroom & Shower Cleaner with Foaming Spray Bottle and tools.
loyalty program
Earn points. Convert points to dollars.
- Exclusive gifts
- Early access
Browse all Foaming Spray Bottle articles
Last reviewed: November 2026 · Koh Australia



